Second version of my Skull that is easly printable in Vase mode

• Halloween decoration
• pot for a plant
• bowl for candies (with optional top cover)
• led lamp
• tealight cover (use bigger size model and not very hot candles)
• etc.

Easy and fast print

Original model size is 112x169x106mm (133mm high with top or in Full mode) Real life skull size should be around 135-145% of this model I made one print 150% and it look bigger than my head (wich is rather typical size)

If you want to sell prints of this models you can buy a Commercial license (for life) Check a LinkTree in my bio Or join my Commercial Plan where you can sell prints of all of my models on Thangs

Sculpted in Blender 3D *I've made some simplifications to this model like filling up holes and reducing some angles to be printable in Vase mode So it's not anatomical correct model but it's much closer to it than my first version :) *

Use Vase mode (spiralize outer contour / spiral vase) for best looking print You can also print it in normal mode with few walls, no infill and no top layers if you want - to make a stronger print (especially if you want a big print with not so big nozzle)

No supports needed

'FULL' model should be printed only in normal mode with top layers and some infill

On photos there is a 70% size model printed with 0.4mm nozzle and line width and 0.1mm layer height - I recommend to use highier line width (around 150% size of a nozzle), I just tested if there will be any holes in the print with such small lines Bigger Skulls, 120% and 150% size printed with 1mm nozzle with 1,2 and 1,3mm line width and 0.5mm layer height Photos from 2025 are with 100% size with a Lid, 0.4mm nozzle, 0.6mm outer line width, 0.16mm layer height

Top Lid should be printed in Vase Mode without any bottom layers and with some brim for stabbility

BUT it will leave a hole in the skull on the back (see photos). There will be another hole on the front side of a Lid but it's inside

You can also print this file in normal mode - but only if you printed the Skull with only one wall to make it fit