'Simple', articulated snake with a smooth body (no scales) in 2 lenghts

Original is with a head and 43 body segments - 239mm long Short and keyring versions are with 14 segments - 92mm long

Original model is printed straight but if you want to print it as big as you can there is an Arc version (the same model but bended - wich uses more square space with more optimal way) On typical printers (~235mm bed plate and more) you should be able to go around 300% (so 27x more volume than original)

If you want to sell prints of this models you can buy a Commercial license (for life) Check a LinkTree in my bio Or join my Commercial Plan where you can sell prints of all of my models on Thangs

I also made a LONG Flexi Snake (1 meter, 3.3ft) Only on Cults for now

Print settings 2-3 walls No infill needed unless you will resize the model No supports needed

Good bed adhesion is needed. Brim is not recommended as you may need some time to remove it Good cooling is recommended (connectors are with bridges)

You can resize it up as you like Resizing down is not recommended but possible (with 0.4mm nozzle it should work even with 50% size but connectors will be much weaker). You may then use a Keyring version as an earring

Break possible connections between segments after print With a clean print it will be moving like it should streight from the bed plate