tracking pixel
Brian H

Vase No. 2

by
LoftedGoods
Follow
Follow
Remix Model
LoftedGoods
LoftedGoods
|
Image 1 of 4
Vase No. 2 3d model
LoftedGoods
LoftedGoods
|
Image 1 of 4
Vase No. 2 3d model
2D
3D
Makes
Vase No. 2 3d model
Vase No. 2 3d model
Vase No. 2 3d model
Vase No. 2 - These are amazing! - 3d model
This model is restricted by licensing terms. 

Sometimes I'll design something with the intention of releasing more variations, and then I'll promptly forget about all that about a day later. That's what happened with this vase. It's the same design as the Mini Magnetic Vase No. 2, but it's fully round and much larger!

Supports None needed!

Scaling Can be scaled up or down however you like.

Orientation The vase should print right side up.

Print Settings

  • .2mm layer height

  • 15% grid infill

  • 2 walls

  • Wall/infill print order - outer/inner/infill

  • I used a monotonic bottom surface pattern and a concentric top surface pattern. I actually used monotonic for the whole thing except the very top. I added a height range modifier and used a concentric top surface pattern. Probably not necessary but it's a habit at this point.

Filament Filament I used for this print: Hatchbox Ash Gray PLA

Filament and hardware/non 3D printed items for this model can be found on my Amazon Storefront, linked here: https://hendricks.design/links/


392 Likes800 DownloadsFebruary 6, 2024


392 Likes800 DownloadsFebruary 6, 2024
This model is restricted by licensing terms.