I've started propagating a lot of my plants so I made this little mount that holds a test tube! These propagation stations are super popular among plant people and sell really well. It's a quick and easy print at around 35 minutes. These smaller prints are usually big money makers as the profit margins are crazy high.

Supports None needed!

Scaling I wouldn't recommend scaling this one since it perfectly fits the test tube and the screw holes are designed specifically for #8-10 x 1 in anchors and screws.

Orientation The mount should be upright and the cleat should have the longer side facing down.

Print Settings

• .2mm layer height

• 15% grid infill

• 2 walls

• Monotonic top and bottom surface pattern

Filament & Hardware Filament I used for this print: Overture PLA Matte Light Brown Test tubes Hardware: #8-10 x 1 in anchors and screws

Filament and hardware/non 3D printed items for this model can be found on my Amazon Storefront, linked here: https://hendricks.design/links/