A planter that's great for hanging plants like pothos, or a small bouquet of succulents. This planter is made up of two parts, an outer pot that can be attached to the wall via command strips or screws, and a removable inner pot that sits inside of it. This makes it super easy to take it out and water in the sink. There's a little room under the inner pot when it's on the wall that can catch residual drips from watering so you don't have to wait to put it back on the wall.

Supports None needed!

Scaling I wouldn't recommend scaling since these perfectly fit the Command Strips or #10 - #12 x 1-1/4" screws and anchors.

Orientation

• The outer pot prints on its back with the flat part on the build plate
• The inner pot prints upright with its bottom on the build plate

Print Settings

• .2mm layer height
• 15% grid infill | 15% gyroid infill for wall mount
• 2 walls

Filament

Bambu Lab Matte PLA

Colors I used:

• Dark Blue
• Ivory White

Hardware

• #10 - #12 x 1-1/4" screws and anchors
• 3M Medium Picture Hanging Command Strips

Filament and non 3D printed items for this model can be found on my Amazon Storefront, linked here: https://linktr.ee/loftedgoods