Over-engineered book/page holder for one-handed reading - comes in two versions: Bookmark and Portable.
Suggested print settings for the Bookmark version:
- Layer height 0.2mm.
- Infill 80%.
- Perimeters: 5.
- No supports are needed.
Suggested print settings for the Portable version:
- Layer height 0.2mm.
- Infill 15%.
- Perimeters: 5.
- No supports are needed.
Assembly Gently flex the "Cap" at the gap before slotting it through the eye.
NOTE Most of our designs are printed and tested on a Prusa Mini and MK4, so tolerances may vary if you are using a different brand. While we strive for a smooth experience with our designs, we appreciate your understanding if tolerance issues arise.
This work is licensed under a Creative Commons (4.0 International License) Attribution—Noncommercial—Share Alike
Category:
97 Likes199 DownloadsAugust 2, 2024
97 Likes199 DownloadsAugust 2, 2024