A replacement for the Thule Wing Bar rubber profile which might come loose and lost when driving at higher speeds.
The model is just updated to slide in easier, the standard length is just about 10cm so you need some to fully cover your bars.
Prints nicely in TPU95A standing upright with no supports, I recommend you use LostInTech's fine TPU cura profile (https://www.lostintech.co.uk/profiles/) to slice this particular model. Prints with 3 perimeters, no infill.
For best results print one at a time - multiples may lead to some unwanted stringing where you least expect it.
Update: included a solid stl and the according step file. The solid is intended to be printed in vase mode. Use TPU95A and the above mentioned profile, select vase mode and set line width to 0.85mm (works fine even when you print with a 0.4mm nozzle)