ABOUT:
Made some anti-skip feet for my pancake compressor that lives on a wooden board under my metalworking bench. Most people keep it under a work bench of some kind. Hopefully it's wood.
This will work with any pancake style compressor's feet. Porter Cable, Craftsman, Ryobi, etc…
If you need another diameter for yours, I can help out.
I only have one pancake compressor so I don't know what sizes are out there.
FEATURES:
Keeps the compressor in one place without skipping. Will accommodate a bolt or screw depending on what size you need. (5mm or 10mm). The feet have an ID of 40mm.
HARDWARE NEEDED:
(3) 5mm or 10mm ¾" or 1" long fasteners.
PRINTING SUGGESTIONS:
I would use PLA, TPU 95a, or ABS. Basically anything shock resistant.
It shouldn't take more than 1hr to print all three.
I would do 10-15% infill.
No brim is needed because of the large print surface.
License CC BY-NC-SA Soldering Base by scupoli is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
FINAL THOUGHTS:
Maybe someone will find this useful.
Cheers!
Visit my blog: https://www.scwd.us
Visit my YouTube Channel