Shower riser rail and head holder.stl

Was in need at a time where shops were closed and ended up making this riser rail and shower head holder. Everything is press fit but an M5 (or something similar that fits inside a 5mm hole) with nut is needed for the adjustable head holder. I used these thumb screw adapters to adjust the holder with my finger.

There are cut-outs for thicker double sided tape on the back of the risers. Can easily be filled out and be replaced with holes if one would wish a more permanent solution.

Printed with: 40% infill 0.2mm resolution Rafts and supports (might work without rafts but I was afraid that the longer tube would fall)

Parts are oriented in the same way I printed them in the .stl

Took roughly 4.5 hours to print