This is an attachment for the LGX Lite Pro that goes over the existing collar and helps guide the filament into the extruder. I didn't need the filament sensor portion, so I removed that from this model. This was inspired by the LGX Lite filament sensor by Max Luck

With the basic PTFE collar that comes with the LGX Lite Pro, I had a lot of issues with filament getting stuck on the outer rim as it enters the extruder. This is most likely because I use 3mm ID PTFE for less friction.

This allows you to use 2mm ID PTFE between this model and the extruder collar, and 3mm ID PTFE from this model to your MMU system. This model fits over the existing collar.

There are a few flavors of models that each do the same thing, but look a bit different

1. Plain
2. LGX Lite Pro emblem
3. Skeletonized

After installing this, I haven't had a single load failure in 20 changes!

Print Settings:

• walls: 5
• Infill 25%
• top/bottom walls: 4

Happy printing!