Secret Squirrel flexi This model was born from a suggestion from a subscriber and probably my most complex flexi. The tail alone took a raft of test prints to make sure it sat over the top pf the squirrel body. of course a squirrel os not complete with out a nut so along with the squirrel ive made an acorn container (available seperatley) the squirrel at 100% fits nicely inside. 0.2 layer height, 15% infill. the body requires no supports. the head head requires just one manual support on the flip out connector joint. this is pre supported in the 3mf. As always its easily colourable with paint fill. Ive used a number of different filaments including ziro gradients including harvest bliss, castle brick and falling leaves, and Bambu basic. please note some of the squirrels pictured have a slightly square base, this is an early print and the final version is rounder