Heart Payment Wand End

An update for the payment wand (wand not included) these fit the payment wand I uploaded a couple of weeks ago.

Due to the shape of the heart you'll need the small cylinder adapter. Place the card in the heart, insert the small cylinder, and then screw on the handle. The cylinder just holds the payment card in place. you must have good adhesion as it prints upright. it will automatically put down a brim. if your cautious about printing you can paint on a couple of small support areas either side. If using a bed slinger I would also suggest rotating 90 degrees to create less resistance when moving.

Filaments, Bambu red.

0.2 layer, 10-15% infill