This model is restricted by licensing terms.
View license.
18 Likes29 DownloadsJuly 11, 2023
This model is restricted by licensing terms.
View license.
Needed to Mount a US-XG-6POE under a desk. Drafted this up and very happy with it!
No supports needed. If printed in a high-temp PETG or ASA you can likely get away with just the front mount. However, adding the rear wouldn't be bad insurance. The Switch can get warm enough that PLA may not be a good long-term solution with its lower glass transition temp.
Categories:
18 Likes29 DownloadsJuly 11, 2023
This model is restricted by licensing terms.
View license.
18 Likes29 DownloadsJuly 11, 2023
This model is restricted by licensing terms.
View license.