0 Likes5 DownloadsApril 2, 2023
A case designed for the Nullbits Nibble65. Made to directly replace the bottom-most PCB plate without needing additional hardware. I went a little crazy giving the board an inner structure to try and capture the light from the bottom LED's and bring it out to the edges, if printed in transparent filament.
The example in the photos was printed in transparent PETG at very low speeds, higher temps and 0.3 mm layer height. I left the model in one piece, if your printer bed isn't large enough to fit in one piece just use your slicer to cut the model in half.
Categories:
0 Likes5 DownloadsApril 2, 2023
0 Likes5 DownloadsApril 2, 2023