A 3D printable version of Vertx's Rapid Access Tab
PRINT SETTINGS Supports: None
EXTRA HARDWARE REQUIRED 1x Zip Tie (2.5mm wide)
ASSEMBLY
- Slip the head of a zip tie into the slot
- Feed loose end of zip tie through existing pull tab, through the hole at the top of the rapid access pull tab, through the head of the zip tie, out the hole on the side of the rapid access pull tab
- Tighten the zip tie as needed and trim flush to the rapid access pull tab
Category:
9 Likes21 DownloadsFebruary 14, 2024
9 Likes21 DownloadsFebruary 14, 2024