Trimble (32mm) Mount.SLDPRT

Designed for Parnell 32mm Trimble 2M pole extensions. Includes a single and double mount in both STL and SLDPRT (roll forward SLDPRT for double mount)

Feel free to not use all the holes provided or use double-sided tape -- though fair warning; the pole does snap into place quite firmly and poorly calibrated printers may create too much friction to safely pull off of drywall. Increase scaling by 0.5-2% before printing if this is the case, as it is also possible to rest a bubble gauge on the upper lip if there is not enough friction to hold the pole in place after scaling.

Print upside down, no supports, medium infill, 3 walls minimum (5-8 recommended)

Edited: 05-10-2024 Optimize clamp diameter