This model is restricted by licensing terms.
View license.
0 Likes1 DownloadsMay 7, 2024
This model is restricted by licensing terms.
View license.
Designed for Parnell 32mm Trimble 2M pole extensions. Includes a single and double mount in both STL and SLDPRT (roll forward SLDPRT for double mount)
Feel free to not use all the holes provided or use double-sided tape -- though fair warning; the pole does snap into place quite firmly and poorly calibrated printers may create too much friction to safely pull off of drywall. Increase scaling by 0.5-2% before printing if this is the case, as it is also possible to rest a bubble gauge on the upper lip if there is not enough friction to hold the pole in place after scaling.
Print upside down, no supports, medium infill, 3 walls minimum (5-8 recommended)
Edited: 05-10-2024 Optimize clamp diameter
Categories:
0 Likes1 DownloadsMay 7, 2024
This model is restricted by licensing terms.
View license.
0 Likes1 DownloadsMay 7, 2024
This model is restricted by licensing terms.
View license.