Hey fellow craftsmen and craftswomen! Just wanted to share my creation - the Druid Horns Headband! Every curve and detail was lovingly crafted, envisioning the perfect addition to any druid cosplay. Whether you're walking through the forest or attending your next con, these horns will surely make your character stand out. Can't wait to see them in action, bringing your magical visions to life!
Printing Settings
Filament Material: PLA
Layer Resolution: 0.2 mm
Infill Percentage: 15%
Supports: Yes
Brim: Yes
Bed Temperature: 60°C
Nozzle Temperature: 210°C
Printing Information
Nozzle Size: 0.4mm
Estimated Printing Time: Approximately 13 hours 35 minutes
Printer Used: Prusa i3 MK3S
Slicing Software Used: PrusaSlicer
Supports: Only Minimal on Headband Connector
Additional Information
Ensure your printer is well-calibrated and the bed is leveled for optimal results. Maintain bed adhesion by keeping the bed clean and free of grease. Use isopropyl alcohol for cleaning and apply adhesive if necessary.
