Hey fellow craftsmen and craftswomen! Just wanted to share my creation - the Druid Horns Headband! Every curve and detail was lovingly crafted, envisioning the perfect addition to any druid cosplay. Whether you're walking through the forest or attending your next con, these horns will surely make your character stand out. Can't wait to see them in action, bringing your magical visions to life!

Printing Settings

• Filament Material: PLA
• Layer Resolution: 0.2 mm
• Infill Percentage: 15%
• Supports: Yes
• Brim: Yes
• Bed Temperature: 60C
• Nozzle Temperature: 210C

Printing Information

• Nozzle Size: 0.4mm
• Estimated Printing Time: Approximately 13 hours 35 minutes
• Printer Used: Prusa i3 MK3S
• Slicing Software Used: PrusaSlicer
• Supports: Only Minimal on Headband Connector

Additional Information Ensure your printer is well-calibrated and the bed is leveled for optimal results. Maintain bed adhesion by keeping the bed clean and free of grease. Use isopropyl alcohol for cleaning and apply adhesive if necessary.