Wasteland Harness Mask by Perihelion Prints

Includes 9 variants:

Open Nose Open Nose, Short Middle Piece Open Nose and Grill Closed Nose and Grill Semi-Open Nose and Grill Closed Nose Semi-Open Nose Semi-Open Nose and Lips Closed Nose and Lips

======

Scaled to fit most adult heads. It's a fairly quick print (with organic supports) so you may want to do a test print or two to confirm fit.

For attachment to head, use elastic cord or ribbon. For fitting, place the mask on your face, lining it up with your nose and the sides of your face.

Ideally you will want to make a strap around your neck and another above your ears, as shown in the pictures. Measure how much ribbon you'l need to go around your neck from the bottom of the mask, then add a bit more and cut two equal halves. Glue one to each side of the mask, and use the leftover length to tie both pieces into a knot/bow behind your head. Repeat this process for the ear straps.

Sculpted in Blender. STL and .blend files included. Dimensions in millimetres.

======

0.20mm layer height recommended.

Use organic supports for best results.

15% infill tested. PLA recommended.

Filament Usage (estimated): 35-45g (based on variant)

Printing Time (estimated): 2h45m - 3h30m (based on variant)

^ Estimates based off slicing for Prusa MK3.9. Your mileage may vary.