Bat Mask by Perihelion Prints

======

For attachment to head, use elastic cord or ribbon. For fitting, place the mask on your face, lining it up with your eyes and the sides of your face.

Measure how much ribbon you'll need to go around your head, then add a bit more and cut two equal halves. Tie a knot at the end of each piece of cord, or glue one to each side of the mask, and use the leftover length to tie both pieces into a knot/bow behind or head. Or you can edit the file to come up with your own solution.

Sculpted in Blender. STL and .blend files included. Dimensions in millimetres.

AI was only used in the creation of the preview photo

======

0.20mm layer height recommended.

Use supports where appropriate - organic supports recommended. See pictures for recommended orientation. You want to print it mostly upright but with a little tilt for more stability.

15% infill tested. PLA recommended.

Filament Usage (estimated): 30g

Printing Time (estimated): 2h15m

^ Estimates based off slicing for Prusa MK3.9. Your mileage may vary.