THIS IS THE 3D PRINT FILE ONLY. This is a Mini Screen Printing Station that is travel sized and easy to use! We use it for demos and for kids to try screen printing on small cards! Please continue to read for more information about this build...

There are 5 .stl files included for this build: The base, the platen, the frame, the squeegee handle, and the emulsion coater.

You will also need...

• Super Glue
• Flat Head Screw #8-32 x 2-1/2in (at any hardware store)
• Screw Nut #8-32 (at any hardware store)
• Rubber Band size #30 ish
• The Frame will need: An old screen printing screen _ (I use 200 yellow mesh)_ _ (Superglue the mini frames onto the screen then cut it up when dry)_
• The Squeegee will need: Rubber Gasket strip _ (1 inch tall, 1/8 inch wide, & about 3 inches long)_

Notes:

• The largest piece is the base which is approx. 100mm x 87mm and 90mm tall
• The suggested artwork size is 1.5 x 2.5 inches. Artwork is NOT included.
• Once the frame & mesh are attached, it behaves like any other frame for emulsion/light box or vinyl stencil.
• Multiple frames can be printed & made so they can be easily switched out from the base
• We recommend a small piece of "PrintGrip" instead of sticky spray on the platen
• 3D prints can be sanded down a bit if it doesn't fit perfectly together (it should)
• Screen Printing Tutorials available on my LinkTree: https://linktr.ee/pencil.n.mouse

Copyright of this design belongs to Pencil.n.Mouse. No attribution needed. Commercial License available through Thangs. Work created as a result from using the screen printer belongs to the artist/screen printer.