0 Likes3 DownloadsApril 4, 2024
Designed this bracket as a quick fix for those pesky bed frame supports that seem to always fall over.
There are two versions (Left/Right) that vary the height of the lower screw. This is to offset the screws so they don't run into each other when using two on one support. I only used one per support in my case, but the option is there if you need both left and right. The screw holes are countersunk for wood screws. I used #8 1" wood screws
Print orientation: Laying on it's side with no supports. .2mm layer height. At least 40% infill for strength.
Categories:
0 Likes3 DownloadsApril 4, 2024
0 Likes3 DownloadsApril 4, 2024