There are three versions- Edit - There are now two additional variations, one that has a thicker base and one with a thicker base and small frame around the design.
I have edited the top magnetic bars to have splits in them, so the clutch is able to be opened much wider than the previous version.
Version 1 if you'd prefer to use snap fasteners (size 15) instead of E6000
Version 2 with the jump ring holes that are closer to the top of the sides
Version 3 with holes that are designed to fit the Chicago style screw fastener listed below (https://a.co/d/eJTBKzu) This is my preferred method.
There is also a template you can print out for cutting your fabric that has two hole options depending on the print that you choose, both in STL and PDF format (A3 and A4 size)
This is printed at .24mm layer height. There is a pause command inserted at layer 2 to add the fabric (two variations now have the pause at layer 3), and another pause at layer 14 to add 10 magnets that are 10mm x 2mm, all facing the same orientation.
There are holes at the top of the clutch for either jump rings or Chicago style rings to attach your strap of choice. More details can be found in the attached printing guide.
This is intended to be printed face down on a build sheet that offers some effect, but the textured effect can be just as cool. I like using tri color silk PLA with these, with the bottom layer as octogram spiral - Change the bottom layer pattern to get a different effect! My favorites are octagram spiral and archimidean chords