tracking pixel
Daniel B

Dragon Scale Cuffs

by
kaizen3dprints
Follow
Follow
Remix Model
kaizen3dprints
kaizen3dprints
|
Image 2 of 5
Dragon Scale Cuffs 3d model
kaizen3dprints
kaizen3dprints
|
Image 2 of 5
Dragon Scale Cuffs 3d model
2D
3D
Makes
Dragon Scale Cuffs 3d model
Dragon Scale Cuffs 3d model
Dragon Scale Cuffs 3d model
Dragon Scale Cuffs 3d model
Dragon Scale Cuffs 3d model

This is a 3D printed dragon scale cuff. The dragon scales are approximately 12mm tall. There are three sizes to choose from. 12cm, 17cm, and 21.5cm. Print time ranges from 1.5 hours to 3 hours, depending on size. I usually print with silk PLA, so my speeds tend to be slower.

There is a pause command added at layer 3. If you'd like a finer quality, you can decrease the layer height above layer 4 with adaptive layer height. Once the pause command takes effect, place your mesh fabric over the print, and place magnets to adhere the fabric to the build plate. Resume the print. They are intended to be used with a small strip of fabric to lace it up. Use for your wrist, upper arm, legs, etc. Just be careful, they're sharp!

These dragon scales were originally created by ShoreyDesigns.


90 Likes279 DownloadsJuly 7, 2024


90 Likes279 DownloadsJuly 7, 2024