Dragon Scale Cuffs
This is a 3D printed dragon scale cuff. The dragon scales are approximately 12mm tall. There are three sizes to choose from. 12cm, 17cm, and 21.5cm. Print time ranges from 1.5 hours to 3 hours, depending on size. I usually print with silk PLA, so my speeds tend to be slower.
There is a pause command added at layer 3. If you'd like a finer quality, you can decrease the layer height above layer 4 with adaptive layer height. Once the pause command takes effect, place your mesh fabric over the print, and place magnets to adhere the fabric to the build plate. Resume the print. They are intended to be used with a small strip of fabric to lace it up. Use for your wrist, upper arm, legs, etc. Just be careful, they're sharp!
These dragon scales were originally created by ShoreyDesigns.
Dragon Scale Cuffs
256x256 PFLAT sheet holder
Massage Roller
Spinning gear fidget ring
Flat band fidget ring
Large TPU foldover bag
Adjustable Strap (48"/122cm max length)
Small Foldover Bag
Customizable Passport Wallet
Tall TPU Bifold Wallet for sewing
Vertical Wallet for Chicago Screws
Square Grid Negative Modifier
Hex Grid Fabric Modifier
Heart Pixel Pattern Textile and Modifiers
Vertical TPU wallet with rivets and grommets
Flippy heart textile and modifiers
Foldable TPU bag sized for Snapmaker U1
Crossed Basket Weave Textile / Modifier
Thin Beaded Textile / Modifier
Magnetic closure textile clutch
