Gridfinity Caliper Holder
1.7K downloads · 4 years ago · This is a caliper holder for the #gridfinity system. The available ones are either too tall for draw
This is a caliper holder for the #gridfinity system. The available ones are either too tall for drawers, or waste space. This one stands the caliper on it's side, saving maximum space. I didn't bother put battery holes in it, because I store batteries elsewhere.
Enjoy!
Gridfinity Caliper Holder
1.7K downloads · 4 years ago in and
Remix of Gridfinity Caliper Holder: fits Pitsburgh and iGaging calipers
Gridfinity Caliper Holder (horizontal)
Gridfinity Caliper Holder
Gridfinity Neiko Caliper Holder
Gridfinity Caliper Holder, remixed for iGaging EZCal
Gridfinity Caliper & Folding Ruler holder
Gridfinity | Caliper Holder - Harbor Freight
Gridfinity Caliper Holder (with screwdriver slot)
Gridfinity Caliper holder for Mitutoyo 530-104
Gridfinity Caliper Holder
Gridfinity Caliper Holder, iGaging
Calipers Box Holder Gridfinity
Gridfinity Caliper Holder, Preciva 150mm
#gridfinity caliper holder
Gridfinity Caliper Holder for Neiko 01407A
Gridfinity Cheapo Caliper Holder
Gridfinity Bigger Caliper Holder
gridfinity cheap amazon caliper holder
Gridfinity Dial Caliper Holder
Very good design, though I had a similar problem as the other comment: the part at the end of the tail doesn't fit well. I'm using really common cheap calipers from Amazon. Doesn't make it unusable but if I print it again I'll modify it slightly there.
Does not fit Mitutoyo 6inch. Otherwise seems like a good design. The space where it gets wider at the tail needs to be moved up by about 12mm.