Great for storage and acts as a tile deck to draw tiles randomly.

Parts:
- Triple-Tube holds 3x20 tiles (410mm tall)
- Triple-Tube-Top covers the top opening
- Triple-Tube-Tab helps push the tiles out
- Triple-Tube-Tab-Tail screws into the the Triple-Tube-Tab and acts as a rail 

Please watch demo video: https://youtu.be/0m2UuSkd_6U 

Hextraction tile dispenser Triple Tube

triple-tube-410.stl

This is remix of the Holographic Tileframe by Zack Freedman prints in one piece, requires no glue or assembly.  Made adjustments to the star design so that it no longer requires support.

With proper cooling the whole part can be printed WITHOUT SUPPORTS!  That's your best bet! Enable special bridge settings in your slicer (slow down, increase cooling for bridges).

If you are weary of the long bridges (shouldn't be!) with a setting of 60 degree overhang angle limit it will print with easy-to-remove, minimal, "normal" supports (see sliced cura screenshot).  But, again, try first without supports, you will be surprised (either way!)

No brims, 50-100% infill. I found it sturdy enough when printed out of PLA+ or PETG.

One-piece no or minimal support Holographic Tileframe

This is remix of the Holographic Tileframe by Zack Freedman prints in one piece, requires no glue or assembly.  I adjusted the star design to reduce support needs.

With 60 degree overhang angle limit it prints with minimal "normal" supports (see sliced cura screenshot).  Experimental bridge-settings recommended.

No brims, 50-100% infill. I found it sturdy enough when printed out of PLA+ or PETG.

One-piece minimal support Holographic Tileframe

Holographic Hypertile one-piece minimal support remix v1.step

Print this 32 slot hextraction board in one piece on a minimum 350x350mm build are printer. I also designed a much more stable 3-point leg system, which can be taken apart for better mobility:
• 6+7+6+7+6 (32) board plate (compatible with standard on and off ramps)
• one-piece 5 segment leg (can be screwed to the bottom triangle)
• one piece triangle with 2 segment leg attached

Use the standard universal foot (or any bolts) to level the triangle and the off ramps. See photo of my setup.

One piece 5-32 Hextraction plate + stable tri-leg system

Overview = 5-32-with stable legs (do not print).stl

Check out my 3D Printing YouTube channel!

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

gerGOPRINT3D

Achievements

Seedling

Voyager

Debutant

Hextraction tile dispenser Triple Tube

One-piece no or minimal support Holographic Tileframe

One piece 5-32 Hextraction plate + stable tri-leg system