A compact and lightweight case for the tabletop game of Cobra Paw. This case is a standalone print and does not require any magnets or hardware.

The game "chips" in 4 stacks of 5 go toward the front of the case and the dice go at the back of the case with the 1 remaining chip on top of the dice.

Recommended printer settings:

• Layer height: 0.2 mm
• Wall line count: 2
• Top/bottom layers count : 4
• Infill density: 20%

Cobra Paw Case © 2023 by Evan Sneath is licensed under Attribution-NonCommercial-ShareAlike 4.0 International.

Paw print on the lid was derived from the following free source requiring attribution: Cat Paw Print Vectors by Vecteezy