2D3D
Makes
528 Likes2.1K DownloadsOctober 23, 2021
Model Snap close connector that's great for holding small items or fidgeting with.
Do not use one of these to hold any sort of load or in a situation that could injure you or someone else.
Print Settings Nothing fancy here. Just regular 0.2 mm layer height and minimum 15% infill.
Hardware Required
- 3 x M3 x 14 mm screws
- 3 x M3 washers
- 50 mm paperclip
Other Info I've added 'Type 2' sides that are thinner at the rear and allow the connectors to connect to each other. Unlike the original model, the Type 2 model does require supports though - take your pick between the two.
Check out Scrath's version of this design that also uses nuts
Category:
528 Likes2.1K DownloadsOctober 23, 2021
528 Likes2.1K DownloadsOctober 23, 2021