Arguably my favourite X-Men (Jean Grey is a close second). Love how the colours turned out for this print, absolute FIRE.
This print uses 5 colours, however I used two different whites for this print, one a low TD and another slightly higher TD. You probably can get away with only using the same white, if you only have one AMS and do not want to bother with swapping out for a 5th spool 🙂
The 3MF as usual has the Bambu profile already set up. If not, use the STL and the instructions below:
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm
Filaments Used:
- PLA Kingroon Black Transmission Distance: 0.4
- PLA BambuLab Basic Red Transmission Distance: 5
- PLA BambuLab Basic Jade White Transmission Distance: 5
- PLA CC3D Lemon Yellow Transmission Distance: 8
- PLA Kingroon White Transmission Distance: 8
Swap Instructions:
- Start with Black
- At layer #12 (0.64mm) swap to Red
- At layer #19 (0.92mm) swap to Jade White
- At layer #20 (0.96mm) swap to Lemon Yellow
- At layer #26 (1.2mm) swap to White for the rest.
If you'd like to support me, you can now subscribe to a Thangs membership plan!
Joining will give you access to a private discord, all paid models, as well as a commercial license to sell the physical prints of my models.
If a Thangs Membership is not your thing, I also have a Patreon with the same perks!