The Gravedigger - Hueforge Print

This is a hueforge print that utilises filament swapping at different layer heights. An AMS is not necessary, but will be very helpful.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

Filaments Used:

• PLA Kingroon Black Transmission Distance: 0.4
• PLA Sunlu Lilac Transmission Distance: 6.6
• PLA Sunlu Beige Transmission Distance: 8.2
• PLA Kingroon White Transmission Distance: 8

Swap Instructions:

• Start with Black
• At layer #7 (0.68mm) swap to Lilac
• At layer #10 (0.92mm) swap to Beige
• At layer #16 (1.4mm) swap to White for the rest.