Skeleton in Blossoms

This is a rather long print (9 hours). If you want to print this quicker, you can certainly do so at a 0.08 layer height instead of 0.04. I also used a strikingly bright combination of colours for this print, and you can certainly swap them for something more amenable to your palette. Have fun!

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm

Filaments Used:

• PLA Kingroon Black Transmission Distance: 0.4
• PLA CC3D Lemon Yellow Transmission Distance: 8
• PLA Sunlu Lilac Transmission Distance: 6.6
• PLA Kingroon White Transmission Distance: 8

Swap Instructions:

• Start with Black
• At layer #20 (0.96mm) swap to Lemon Yellow
• At layer #33 (1.48mm) swap to Lilac
• At layer #47 (2.04mm) swap to White for the rest.