It's everyone's favourite Elixir obsessed alien from FF8!
This cutie was sculpted entirely in Nomad Sculpt and I had a blast doing so. I've included a 3MF for an AMS multicolour print, as well as a single colour 3MF. And the STL as usual.
Print Recommendations: I printed this at 0.16mm layer height, 5% infill, with organic tree supports. But you can print in whatever settings you prefer. It's not a very complicated print!
The multicolour one does take about 2+ hours for a single PuPu though. The single colour takes much less time. 🙂 ENJOY!
Categories:
1 Likes1 DownloadsMay 24, 2024