Pallet Town - HueForge Print

Another addition to the Retro Gaming set - everyone's favourite starter town! This was a hard print to set up. I had to cheat and swap some yellows with some reds (I hope it's unnoticeable enough!) but otherwise, it's really really neat!

It uses 8 unique filaments and 10 swaps (one repeated colour), so unfortunately it is best printed with 2 AMS - or you will have to babysit and swap quite a bit!

The included 3MF will have all the swaps already loaded for Bambu Studio (just make sure you assign your own colours accordingly!). If you are not using Bambu Studio, please use the STL and the print instructions below!

Print Instructions Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm

Filaments Used:

• PLA Kingroon Black Transmission Distance: 0.4
• PLA Chrominal Serpent Green Transmission Distance: 8.2
• PLA CC3D Lemon Yellow Transmission Distance: 6.8
• PLA BambuLab Basic BambuLab Green Transmission Distance: 1.2
• PLA Chrominal Penumbra Gray Transmission Distance: 6.9
• PLA Kingroon White Transmission Distance: 5.8
• PLA+ Overture Dark Blue Transmission Distance: 4
• PLA BambuLab Tough Vermilion Red Transmission Distance: 2.7

Swap Instructions:

• Start with Black
• At layer #10 (0.56mm) swap to Serpent Green
• At layer #13 (0.68mm) swap to Lemon Yellow
• At layer #17 (0.84mm) swap to BambuLab Green
• At layer #20 (0.96mm) swap to Penumbra Gray
• At layer #22 (1.04mm) swap to White
• At layer #29 (1.32mm) swap to Penumbra Gray
• At layer #34 (1.52mm) swap to Dark Blue
• At layer #36 (1.6mm) swap to Vermilion Red
• At layer #42 (1.84mm) swap to White for the rest.