cbobo2uco1.7K followers

Easter Egg Capsule Collection 2025 3d model

Easter Egg Capsule Collection 2025

3.9K downloads · 1 year ago · A collection of 10 Easter egg capsules that can be used to store candy and other prizes for egg hunt

Description

A collection of 10 Easter egg capsules that can be used to store candy and other prizes for egg hunts. You will need to print the adapter part in order to join each egg together. Supports were used to print the Egg Shuttle Back, Cross Egg Top and Bottom, and Tear Egg Top parts.

Tags:

Community Makes (3)

I killed off two rolls with not much left. There are (3) Mika3D bi-color PLA silk filaments in there. (orange/black, green/purple, and red/black) - toward the end of these rolls the bias between colors swaps back and forth creating the lines you see. That's uncommon in the first half of the rolls.

Community Makes (3)

Discussions

travis711231 year ago

How do these work at a smaller scale?

stefan.bugovsky1 year ago

Domenick_s1 year ago

Are these files available for print and sell? What license are these files under? I apologize for these questions, I am new to Thangs. Feel free to educate me on how it works. I see you have membership plans, does this allow me to 3D print and sell your designs? Thank you.

Myoglobin1 year ago

Also would appreciate an answer to this!

Domenick_s1 year ago

@cbobo2uco I love your designs but could you tell how Thangs work? If you aren't allowing a commercial license that's fine and acceptable if becoming a member gives you a commercial license that is good too. I just want to be fair as well as go by the rules. An answer would be appreciated. Thank you again. Domenick

Bill Shirley1 year ago

I killed off two rolls with not much left. There are (3) Mika3D bi-color PLA silk filaments in there. (orange/black, green/purple, and red/black) - toward the end of these rolls the bias between colors swaps back and forth creating the lines you see. That's uncommon in the first half of the rolls.

PrinterBambu Lab A1

MaterialPLA

SupportsNone

BrimNo

k-yde1 year ago

I have just printed one of Your eggs. But I cant se how to connect the two halves. Do I have to glue the connector to the top part to connect the two halves. And can i then be able to open the egg afterwards?

cbobo2uco1 year ago

You will have to glue the adapter part to the lower half of the egg. This will allow the two halves to be joined together. I hope this helps.

k-yde1 year ago

Thanks