tracking pixel
Bryan P

Small Thread Fork - Screwdriver Holder for Multiboard.stl

by
bryanpacep1
Follow
Follow
Remix Model
bryanpacep1
bryanpacep1
|
Image 3 of 5
Small Thread Fork - Screwdriver Holder for Multiboard.stl 3d model
bryanpacep1
bryanpacep1
|
Image 3 of 5
Small Thread Fork - Screwdriver Holder for Multiboard.stl 3d model
2D
3D
Makes
Small Thread Fork - Screwdriver Holder for Multiboard.stl 3d model
Small Thread Fork - Screwdriver Holder for Multiboard.stl 3d model
Small Thread Fork - Screwdriver Holder for Multiboard.stl 3d model
Small Thread Fork - Screwdriver Holder for Multiboard.stl 3d model
Small Thread Fork - Screwdriver Holder for Multiboard.stl 3d model
43 Likes158 DownloadsFebruary 15, 2024


For holding screwdrivers. Prints "flat" like most of the Multiboard stuff. Should be wide enough to fit most screwdrivers, but is thin enough to fit them in adjacent peg holes.

I probably rounded the rods a little too much, so you may run into issues with the print not sticking if you don't like using skirts/ your bed adhesion isn't super good, but I was able to print it with no issues.

Feedback welcome.

Category:


43 Likes158 DownloadsFebruary 15, 2024
1




43 Likes158 DownloadsFebruary 15, 2024