Mount block for 4 Nimbles V1 on a Kraken

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:2786223.

The mount block allows you to bolt 4 Nimbles on a E3D-Kraken hot end. This is experimental, mainly because it needs a PTFE tube that curves into the Kraken. This is done to leave the middle available for the water cooling and to still be able to open the Nimble breeches. I have tried a curved PTFE tube on a small test block and had no trouble printing but ymmv. Have not tested it to the fullest extent I normally do. Therefore, WiP.

Edit 1: Corrected an error in positioning the PTFE tubes. Also added a little cut out for the Nimble legs. And added then IGES file.

The STL models are checked and optimised. The parts that need a different orientation to print properly are rotated to the preferred printing position.

With an installed weight of less than 27 grams on your carriage/effector the Zesty Nimble is the smallest and lightest extruder you can buy, it has ample torque and can be mounted in multiple orientations.

The Nimble is available from Zesty Technology.