Keyhole slots are on the back of a lot of wall mountable equipment. These are a set of strong Keyhole Hangers for for use with the Multiboard system.
I needed something a little stronger then just plastic pegs in the Keyholes. These holders are strong and can hold a good amount of weight and pull down torque.
10mm length screws seem best.
It comes with Mid Thread and Big Thread mounts. Mid Thread supports M3 and M4 screws. Big Thread supports M4 and M5 screws.
There are Heatset inserts holders and Screw holders
Heatset Inserts:
- M3 Heatset should be M3x6x5
- M4 Heatset should be M4x6x6
- M5 Heatset should be M5x6x7
Blue Thread Lock will hold the Screws using the Heatset inserts into place.
Screw holders allow you to self tap a screw just by screwing it in.
Print as oriented with no supports and standard Multiboard settings (3 walls, 15% infill)