This is a fully 3D Printable version of Zack Freedmans Flip flop tile - see here: https://thangs.com/designer/ZackFreedman/3d-model/Hextraction%20Flip-Flop%20Tile-856502

When you print, use tree supports underneath the section that touches the flipper. Use a file, or something sharp to file down the part of the supports where it touches the tile, it can get stuck otherwise. To assemble, lift up the flap that touches the flipper, slide the flipper under, and align the notch underneath the flipper with the hole on the tile.

Comment and give me any feedback, all I did was add a little arm to the tile, so kudos to Zack who actually made it.