From me (StarMouse3D):

🏡 A fully modular barn—all parts print separately in different colors (no waste!) and snap together with a satisfying click 🌱 A grass base with fencing 🥕 A tiny carrot plot with loose, removable carrots 🛁 A little water trough with water that snaps in snug 🐑 A tiny/mini four-legged sheep to waddle around the farm 🪴 A bush, and a little shelf where you can store chickens or eggs inside or outside the barn! Regular mini carrots and tomatoes from picture are not available in this set and just props for a picture!

Hi there! I'm Mouse and I love art & 3D printing. I am inspired by cottage-core, fantasy, and kawaii things! Thank you for taking the time to read this. :)

If you like this design, please check out my other models: https://thangs.com/designer/StarMouse3D

StarMouse3D creations are protected by copyright. These files are for personal use only, and you do not have the right to sell the files or the models without explicit consent from me.

To legally obtain permission to sell PHYSICAL prints you may obtain permission to sell every model as an active Thangs supporter through this link: https://thangs.com/designer/StarMouse3D

Please do not share digital files! Thank you.

Please be warned that these models are not recommended to be printed for young children, or anyone at risk of a choking hazard. There are small parts that can be broken off if roughly handled. Print at your own risk!

🛠️ Barn Building Tips (Read Me!): Some pieces are tight on purpose! Use firm pressure to snap them in.

For the roof, push slightly on the walls with the tabs while attaching—it’s designed to be removable for easy play, but stay secure so it doesn't fall off!

The door frame slots in before you slot the side walls in, but a bit of glue helps it stay secure.

Carrots are all loose by default, so you can arrange or glue them depending on your preference.

The brown roof is loose too—you can keep it off for a flat barn top, or glue it in place if you want it permanent.

The water piece is a tight snap! Push it in straight—if it’s tricky, pliers help. Or, print the water 1% smaller for easier fitting!

Recommended Print Settings: Layer Height: .16 Infill: 15% Supports: Not needed Adaptive Layer Height recommended (but will slow print down)

Pro Tip: If the first layers struggle to stick, try slowing down your first layers or increasing the bed temp slightly.