Spooky House (HueForge)

I was originally going to release this around halloween but decided to release early.

150x150

Print at 100% infill with a layer height of 0.1mm with a base layer of 0.2mm

Filaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA PolyLite Pro Blue-Green Transmission Distance: 0.5 PLA PolyLite Yellow Transmission Distance: 11 PLA PolyLite Natural Transmission Distance: 21 PLA PolyTerra Cotton White Transmission Distance: 2.5

Swap Instructions: Start with Black At layer #5 (0.6mm) swap to Blue-Green At layer #8 (0.9mm) swap to Yellow At layer #10 (1.1mm) swap to Natural At layer #24 (2.5mm) swap to Cotton White for the rest.

The model is not as tall as your last slider. Consider checking the Full Range button or change your Depth Mode.