This is part of our 2023 Valentine's collection. The rose comes in two parts: the flower and the stem. The stem has a square slot inserted into the flower and can be glued for permanent assembly. -Looks great in a lot of different colors, so feel free to experiment with untraditional colors; they might surprise you
- It makes a perfect gift for that special someone and, quite frankly, is a lovely piece to have for yourself.
Print Settings:
For the Flower:
-0.1mm - 0.2mm layer height
-No supports
-15-25% infill
For Stem:
-0.08 - 0.1mm layer height
- Position it parallel to the build plate with supports enabled. The stem should be floating midair above the build plate, completely held up by supports underneath it. (Note you may need to adjust the support generation angle in the slicer; make sure that the supports generate around the leaves, not just underneath, to ensure that they print properly)
-100% infill
16 Likes16 DownloadsJune 15, 2023