tracking pixel
Roy B

Rose Pen

by
RWBDesigns
Follow
Follow
Remix Model
RWBDesigns
RWBDesigns
|
Image 1 of 8
Rose Pen  3d model
RWBDesigns
RWBDesigns
|
Image 1 of 8
Rose Pen  3d model
2D
3D
Makes
Rose Pen  3d model
Rose Pen  3d model
Rose Pen  3d model
Rose Pen  3d model
Rose Pen  3d model
Rose Pen  3d model
Rose Pen  3d model
Rose Pen  3d model
This model is restricted by licensing terms. 

Description Introducing the Rose Pen, a model that combines the elegance of a rose with the practicality of a pen.

This model includes two holders for the pen as shown in green and red in the above pictures: one that holds the pen at a slight angle and another that holds the pen upright. Additionally, the model includes two distinct flower designs for the rose, allowing for customization to suit individual preferences.

Pen Insert: 🔗 Link to purchase pen inserts

Assembly: The pen refill should be inserted into the rose stem and slid smoothly up to a certain point. After that, press the pen against the table with a little force to pop the refill into the stem permanently. The plastic on the pen refill should sit flush with the end of the stem.

🚨🚨🚨🚨🚨🚨

This model is for personal use only. If you want to sell physical prints of our designs, or you want to support us, please SUBSCRIBE TO OUR THANGS MEMBERSHIP PLAN : https://than.gs/u/161490?plans=true

🚨🚨🚨🚨🚨🚨

Print Settings:

Stem:

Orientation: Oriented the stem at a 30-degree angle, with the leaves close to the bed and the hole on the stem raised up. Infill: 100% Supports: Enabled and set to tree supports; build plate only Layerheight: 0.1mm

Rose Head:

Orientation: place the flat side on the print bed with the flower upright Infill: 25% Supports: no supports Layerheight: 0.1mm

Pen Holders:

Orientation: place the flat side on the print bed with the hole facing upward Infill: 60-100% Supports: no supports Layerheight: 0.1mm

Categories:


44 Likes130 DownloadsJune 7, 2024


44 Likes130 DownloadsJune 7, 2024
This model is restricted by licensing terms.