Cupholder Trashcan

Cupholder trashcan that has been modelled for a Volkswagen Up! but it can be universally used.

!!!! There are 3 files for the lid, you can either pick the "Full-Lid" which contains the necessary items in one STL (arranged to fit an Ender 3 V2) or you can print the lid and ring separately.

Other things needed are:

• two 6mm x 2mm magnets
• M4 bolt and nut

The magnets are friction fit and should fit fine when pressed into the corresponding sockets (a bench vise might come in handy). For the M4 bolt it might be necessary to use a drill to make the hole a bit bigger but normally it should also fit.