I printed mine with 0.2mm layer height on a 0.4mm nozzle. Be mindful of the supports it's recommended but not on 100% of the lower side. I make sure there is support about every 2cm on the underside of the larger models. 

Dimensions are listed on the STL as number of long sides by the number of short sides. 

Custom Bins for Storehouse Medium or Small Parts Storage Case

3lx2s.stl

This is a model kit for Sutro radio tower in San Francisco. Finished model is ~30cm (12in) and can be printed on a Prusa MINI if you're careful.

The kit requires some sanding and glue to fully assemble.

Sutro Tower

Sutro.step

Perfect for Holding your 8 or 8.6 oz beverage (Redbull maybe) in a Trashcan like receptacle.

Included files
• Step file for reference
• Can Body
• Lid
• Wheel (print 2)

Prints in 4 pieces (2 wheels, the can, and lid) and 1.75mm filament functions as the hinge and axle. For the axel to retain the wheel I melted a bit of the filament with a soldering iron and glued in place.

Printed with Polymaker Green, and Black at 10% infill



Trash Can Cup 8 oz

Trash Can Cup 8oz.step

Perfect for Holding your 16oz beverage in a Trashcan like receptacle.

Included files
• Step file for reference
• Can Body
• Lid
• Wheel (print 2)

Prints in 4 pieces (2 wheels, the can, and lid) and 1.75mm filament functions as the hinge and axle. For the axel to retain the wheel I melted a bit of the filament with a soldering iron and glued in place.

Printed with Polymaker Green, and Black at 10% infill



Trash Can Cup 16 oz

Trash Can Cup 16 oz v2.step

Perfect for Holding your 12oz beverage in a Trashcan like receptacle.

Included files
• Step file for reference
• Can Body
• Lid
• Wheel (print 2)

Prints in 4 pieces (2 wheels, the can, and lid) and 1.75mm filament functions as the hinge and axle. For the axel to retain the wheel I melted a bit of the filament with a soldering iron and glued in place. 

Printed with Polymaker Green, Blue, and Black at 10% infill

Trash Can Cup 12 oz

Wheel R

Wheel L

Can Body

Set of three two piece stands for displaying a 440 cinderella bowl set. Set is intended for use with half inch o.d. rubber hose as feet on the ends of the models

Pyrex Cinderella Bowl Nesting Stand

Bowl Stand lrg A.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

eguidry

Achievements

Seedling

Explorer