tracking pixel
Olo Deepdelver

Vacuum Bed Riser Battle Kit

by
Olo Deepdelver
Follow
Follow
Remix Model
Olo Deepdelver
Olo Deepdelver
|
Image 1 of 8
Vacuum Bed Riser Battle Kit 3d model
Olo Deepdelver
Olo Deepdelver
|
Image 1 of 8
Vacuum Bed Riser Battle Kit 3d model
2D
3D
Makes
Vacuum Bed Riser Battle Kit 3d model
Vacuum Bed Riser Battle Kit 3d model
Vacuum Bed Riser Battle Kit 3d model
Vacuum Bed Riser Battle Kit 3d model
Vacuum Bed Riser Battle Kit 3d model
Vacuum Bed Riser Battle Kit 3d model
Vacuum Bed Riser Battle Kit 3d model
Vacuum Bed Riser Battle Kit 3d model
This model is restricted by licensing terms. 

Model has been moved to Printables.com:

I want the vacuum robot to be able to go below the kid's bed.

So here is my solution:

  • Rising the bed by 27mm with the 3D feets + couple of millimeters from the felt patch

    • feet are designed for a 60mm x 40mm rectangular wooden feet (see pictures)
    • Felt diameter needs to be D35mm or below
  • Cutting about 25mm of wood on one of the side of the bed with a jigsaw and then hiding my crime with a custom piece.

That give an additional ~5 cm to the robot to go below the bed, given that the original feet where about 5cm too.

Most robot are about 10cm high. I have a roborock (see picture)

Print:

  • Advice: Make the feet strong !

Assemble:

  • Screw the feet in place with a wood screw (length 30mm or more - Diam 5mm or below)
  • Stick the felt below the feet (D35mm felt of below)
  • Seems a bit specific but I hope it helps someone !

1 Likes2 DownloadsDecember 2, 2022


1 Likes2 DownloadsDecember 2, 2022
This model is restricted by licensing terms.