This model is restricted by licensing terms.
View license.
Designed to keep Blueland or other dissolvable tablets at the ready!
Print Recommendations: Print Material: PLA Infill Percent: 15% Perimeters: 2 Layer Height: .2 (larger layer heights will work just fine but will be more noticeable) Supports: NONE Print Orientation: Place the bottom of the organizer against the build plate (essentially in the orientation that it will be used)
Additional Parts Required: • Double Sided Tape • Amazon Link to 3M .4 inch double sided tape https://a.co/d/3n44GFr (This adhesive twists off easily and doesn't leave residue.)
Assembly: • Add a small amount of double sided tape to the back of the organizer to make sure everything stays in place.
Category:
1 Likes1 DownloadsJuly 11, 2024
1 Likes1 DownloadsJuly 11, 2024
This model is restricted by licensing terms.
View license.