Keep your contact routine simple with this drawer organizer. Includes left and right eye trays to keep everything straight.

Print Recommendations: Print Material: PLA Infill Percent: 15% Perimeters: 2 Layer Height: .2 (larger layer heights will work just fine but will be more noticeable) Supports: NONE Print Orientation: Place the bottom of the organizer against the build plate (essentially in the orientation that it will be used)

Additional Parts Required:

• Double Sided Tape
• Amazon Link to 3M .4 inch double sided tape https://a.co/d/3n44GFr (This adhesive twists off easily and doesn't leave residue.)

Assembly:

• Add a small amount of double sided tape to the base of the organizer to make sure everything stays in place.