AirPods Max Charging Stand

Designed to keep your AirPods charged and at the ready. Use it as a headphone stand or add a lightning cable (link below) to add charging capability.

Fits AirPods Max (lightning cable version).

Note: This design will only fit the lightning cable linked below. It will not fit other lightning charging cables.

Print Recommendations: Print Material: PLA Infill Percent: 15% Perimeters: 2 Layer Height: .2 (the tolerances on this design are very precise and all other layer heights will not work if you are adding the lightning cable for charging capability) Supports: NONE Print Orientation: Place the holder on the build plate standing upright essentially in the orientation in which it will be used.

Additional Parts Required: • Braided lightning cable - (Lightning to USB-C) Amazon link: https://a.co/d/eyiupJM Note: this design is made specifically for this lightning cable. Other cables will not fit. • Double Sided Tape - Amazon Link to 3M .4 inch double sided tape https://a.co/d/3n44GFr (This adhesive twists off easily and doesn't leave residue.)

Assembly:

1. Press the lightning cable into the charging stand. This is a tight fit by design so you will need the handle of a tool or another hard flat object to push the connector into the stand.
2. Pull the lightning cable cord taught and push it into the groove on the base of the stand.
3. Place a small square of double sided tape to each corner of the base of the headphone stand before securing it to your desk.